Filter
Top Products
Features 3-43
3 Features
L
Language Selection
The selected language in program [615] is shown on the LCD display of a proprietary
telephone during operation and Proprietary Telephone Settings, but not used during System
Programming. The selected language in program [806] is used for an SMDR printout.
• Required System Programming
[615] LCD Language Assignment
[806] SMDR Language Assignment
☞
Limited Call Duration
The system disconnects outside outgoing calls when a specific timer expires. The timer is in
effect when making an outside call, transferring an intercom call to an exchange line or
forwarding an intercom call to an exchange line. Limiting the time of the call can be
assigned through System Programming.
• An alarm tone will be sent to both parties 15 seconds before the assigned time limit.
• Required System Programming
[212] Exchange line Duration Time Limit
[613] Exchange line Duration Time Limit Selection
• Related Feature References
Call Forwarding, Call Transfer – to Exchange line
☞
!
!
Line Access Keys
A proprietary telephone (PT) user must assign one of the following 3 types of line keys to
flexible line keys in the Proprietary Telephone Settings. This permits making or receiving
outside calls. The default setting for the flexible line keys (CO 1 – CO 6) are Single
Exchange Line (S-CO) keys. CO 1 corresponds to exchange line 1, CO 2 corresponds to
exchange line 2, etc.
<Trunk Group (G-CO) Key>
Receiving or making outside calls is on an trunk group basis. The trunk group is assigned in
program [404]. Any incoming call from any exchange line in the trunk group arrives at the
G-CO key. To make an outside call, the user can access an idle exchange line in the group
by simply pressing the assigned G-CO key.
<Single Exchange Line (S-CO) Key>
Receiving or making outside calls is done using a specific exchange line. An incoming call
from the specific exchange line arrives at the S-CO key. To make an outside call, the user
can access the specific exchange line by simply pressing the assigned S-CO key.
<Other Exchange Line (O-CO) Key>
Exchange lines, which are not assigned to an S-CO or G-CO key, can be assigned to a
flexible line key as the O-CO key. An incoming call on an exchange lines arrives at the
O-CO. To make an outside call, the user simply presses the assigned O-CO key.
PSQX1708ZA-04E.QX 99.10.15 10:31 AM Page 43