Filter
Top Products
3-26 Features
D
3 Features
*1: The DISA Delayed timer starts. This is the time between a call reaching the system and being
received. The time is assigned in program [504].
*2: When the assigned time period in program [519] expires, the system sends a short beep to the
caller.
*3: The Intercept Timer for Internal DISA starts. This is the time the system waits for the number
sent by the caller. If nothing is entered by the caller during this time, the system will regard it as
“Nothing is dialled.” The time is assigned in program [515].
*4: The system can accept the following numbers:
• 200 through 299 as an extension number.
• 0 or 9 as the operator call number when the operator is assigned in program
[008] “Operator Assignment” and “Without AA” is assigned in program [500]. Even if “With
AA” is assigned, 0 or 9 is regarded as the operator call number if nothing is assigned to “0” or
“9” in program [501].
• 0 through 9 as a built-in auto attendant number when “With AA” is assigned in program [500].
The DISA AA Wait timer starts after receiving the first 1-digit number. If the timer expires, the
system will assume that the first digit is an AA number. The time is assigned in program [517].
*5: The DISA Ring Timer Before Intercept starts. The destination telephone(s) will ring for the time
programmed in [508].
*6: The system treats the call according to program [507] as follows.
• Disconnect – the call is disconnected.
• Intercept – the call is sent to the extensions programmed in [408]-[410] “Flexible Ringing
Assignment – Day/Night/Lunch”.
If the call is still not answered within the time programmed in [509], it will be disconnected.
*7: If the destination extension belongs to a hunting group and all extensions in the group are busy,
the system will check the DISA Busy Mode. If the destination is a DISA ring group, the DISA
Busy Mode will not work for the call. The system regards the call as unanswered.
*8: The DISA Busy Mode is selected in program [506]. There are 3 modes as follows.
• Disconnect – the caller hears a busy tone and a call is disconnected.
• Call Waiting – the destination extension hears a call waiting tone if they have enabled Call
Waiting.
• DISA2 – if “MODE2” is assigned in program [502] and a message is recorded in OGM2, the
caller will hear the message and the system waits for the new destination.
PSQX1708ZA-04E.QX 99.10.15 10:31 AM Page 26