Filter
Top Products
3-70 Features
U
3 Features
*1: An OGM is sent to the caller.
When the system detects a cyclic tone or CPC signal while the OGM is being sent, the call is
disconnected.
*2: Music on hold is selected in program [111] as follows.
• External – Uses an external music source, such as a radio.
• Tone – Uses the cyclic tone equipped with the system.
*3: When an extension in the UCD group is available.
*4: The system holds the call until the assigned time in program [521] expires.
*5: OGM repeats the assigned time intervals in program [522] within the assigned time in program
[521].
*6: The OGM Mode is selected in program [502].
*7: The system treats the call according to program [523] as follows when the assigned time in [521]
expires.
• Disconnect – The call is disconnected.
• Intercept – The call is sent to the extensions programmed in [408]-[410].
*8: The system treats the call according to program [523] as follows when the assigned time in [521]
expires.
• Disconnect – The call is disconnected.
• Intercept – The other OGM leads the caller to the DISA feature (☞ “Direct Inward System
Access (DISA)” in this section).
*9: The system treats the call according to program [524] as follows when the assigned time in [525]
expires.
• Disconnect – The call is disconnected.
• Intercept – The call is sent to the extensions programmed in [408]-[410].
*10: If the caller did not hear an OGM, the call will not be disconnected until the caller goes on-hook.
*11: The UCD Ring Timer after Intercept starts. The destination telephone(s) will ring for the time
programmed in program [526]. If the call is not answered during the programmed time, the call
will be disconnected.
PSQX1708ZA-05E.QX 99.10.15 10:31 AM Page 70