Filter
Top Products
System Programming 4-63
4.2 System Programming [510], [513]
Selects the operation when the system does not receive either DTMF signals or a FAX
(CNG) tone after a programmed length of time. If the optional card is installed, then use
program [505] “DISA Waiting Time after OGM”. If the optional card is not installed, then
use program [515] “Intercept Time for Internal DISA”. Intercept or Disconnect is
available.
Intercept: The call is directed depending on programs [408]-[410] “Flexible Ringing
Assignment–Day/Night/Lunch” (Intercept Routing – No Answer feature).
The destination telephone(s) will ring for the time programmed in
[509] “DISA Ringing Time after Intercept”.
Disconnect: The call is disconnected.
Default DISA 1 and DISA 2 – Intercept
• Feature References
Section 3, Features
Direct Inward System Access (DISA), Intercept Routing
[510] DISA No Dial Mode
1
5
NEXT
0
STORE
END
SELECT
(Intercept/
Disconnect)
(DISA1/
DISA2)
To continue
☞
NEXT
Assigns the number of times a cyclic tone is detected while the DISA outgoing message is
sent so that the system can recognise the end of the DISA call.
* Disable (Does not detect)
Default 4 Times
• Feature References
Section 3, Features
Direct Inward System Access (DISA), Uniform Call Distribution (UCD)
[513] Cyclic Tone Detection*
1
1
5
NEXT
3
STORE
END
SELECT
(Disable*/
2/3/4 Times)
☞
*
1
: Required only when the optional OGM/FAX Detection
Card is installed.
PSQX1708ZA-10E.QX 99.10.15 1:06 PM Page 63