Filter
Top Products
Features 3-59
3 Features
R
Receiving Calls
Allows an extension user to receive an intercom or outside call by going off-hook. A
proprietary telephone user can also receive a call by pressing the rapid flashing CO or
INTERCOM button, and talk (handsfree mode) if the telephone has the SP-PHONE button.
• A proprietary telephone user can select the Line Preference for incoming outside calls.
See “Preferred Line Assignment — Incoming” in this section.
• Required System Programming
[408]–[410] “Flexible Ringing Assignment — Day/Night/Lunch”
[411]–[413] “Delayed Ringing Assignment — Day/Night/Lunch”
• Related Feature Reference
Preferred Line Assignment — Incoming
• Operating Instructions Reference
1.4 Receiving Calls, “Receiving Calls”
☞
!
!
Recall Button on a Single Line Telephone
Pressing the Recall button is used to allow a single line telephone user to hold a call for
transferring or holding, if the recall time is within the assigned time in program [207]. The
procedure to transfer a call or hold is determined in program [104] “Hold Mode Selection”.
Pressing the Recall button can be also used to disconnect a call, if the recall time is more
than the assigned time in program [207].
• If “MODE 1” was selected in program [207], the system will recognise pressing the
Recall button as hooking, while a busy tone or reorder tone is sent or during a
conversation. The system will recognise as 1 being dialled in the pulse mode, while a
dial tone is sent. The system can refuse receiving a pulse signal by selecting “Disable” in
program [614]. Therefore, even if the Recall button is pressed during a dial tone, the
system will regard it as hooking.
• Required System Programming
[207] Recall Timing Range Selection
[614] Internal Pulse Detection
☞
!
!
PSQX1708ZA-05E.QX 99.10.15 10:31 AM Page 59