Filter
Top Products
3-58 Features
P-R
3 Features
Pulse to Tone Conversion
Allows an extension user to change the dialling mode from Pulse to Tone after entering a
telephone number to access services, such as computer telephone services or Voice Mail,
which require tones.
• This feature only works for exchange lines which have set “Pulse Mode” or ”Call
Blocking Mode” in program [401].
• Changing from Tone to Pulse is not possible.
• Required System Programming
[401] Dial Mode
• Operating Instructions Reference
1.7 Useful Features, “Pulse to Tone Conversion”
☞
!
!
Recall
The RECALL button is used to allow a proprietary telephone user to disconnect the current
call and originate another call without hanging up. This is activated when “MODE2” is
selected in program [110] and the RECALL button is pressed for longer than the time
programmed in [418]. When “MODE1” is selected in program [110], the RECALL button
can be used to access features of the Local Exchange or host PBX (External Feature Access).
It is performed by putting the current party on hold and sending a recall signal while having
an outside call.
• Assigning the External Feature Access feature to any flexible button is useful when
“MODE 2” was selected in program [110]. This can be done from any extension by
assigning the RECALL button to a One-Touch Dialling button (☞ Operating Instructions,
1.2 Proprietary Telephone Settings, “Customising the Buttons on Your Telephone”,
One-Touch Access for System Features). When the assigned button is pressed, a recall
signal is sent during the programmed time in [418].
• Required System Program Address
[110] Recall Key Mode
[418] Recall Time
• Operating Instructions Reference
1.7 Useful Features, “External Feature Access”
☞
!
!
PSQX1708ZA-05E.QX 99.10.15 10:31 AM Page 58