Filter
Top Products
System Programming 4-17
4.2 System Programming [104]-[105]
[104] Hold Mode Selection
You can select how to hold a line and transfer a call to another extension with a single line
telephone (SLT), Hold-1, Hold-2 or Hold-3. If the following occurs frequently with an SLT,
select “Hold-2” or “Hold-3”.
• Nobody answers when a call is received.
• A busy tone is heard even though nobody is using the exchange line.
If a call is not terminated after going on-hook, the above cases occur. To avoid these
problems, select “Hold-2” or “Hold-3”. Every call will be terminated unless 50 is dialled
after pressing the Recall button in the Hold-2 and Hold-3 modes.
Hold-1: To hold a line or transfer a call, press the Recall button.
Hold-2: To hold a line, press the Recall button and dial 50. To transfer a call, press the
Recall button.
Hold-3: To hold a line or transfer a call, press the Recall button and dial 50.
Default Hold-1
• Feature Reference
Section 3, Features
Hold
4
0
1
NEXT
SELECT
STORE
END
(Hold-1/Hold-2
Hold-3)
[105] Conference Tone
Enables or disables the confirmation tone before starting or ending a conference call
established by the Conference feature or Executive Busy Override feature.
Default Enable
• Feature References
Section 3, Features
Conference (3-party), Conference (5-party), Executive Busy Override
5
0
1
NEXT
SELECT
STORE
END
(Enable/
Disable)
☞
☞
PSQX1708ZA-07E.QX 99.10.15 10:34 AM Page 17