Filter
Top Products
4-68 System Programming
[524]-[526] 4.2 System Programming
Assigns the length of time for the Intercept Routing – No Answer feature (☞ [524] “UCD
Intercept Mode”, Intercept). When the time expires, the system starts to redirect the call to
the programmed extension(s).
Default 20 seconds
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)
[525] UCD Ringing Time before Intercept*
1
2
5
NEXT
5
STORE
END
SELECT
(10/20/30/
40/60/120 sec)
Assigns the length of time to call the extension(s) where a call is redirected by the Intercept
Routing – No Answer feature (☞ [524] “UCD Intercept Mode”, Intercept) after the time
programmed in [525] “UCD Ringing Time before Intercept” expires.
Default 20 seconds
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)
[526] UCD Ringing Time after Intercept*
1
2
5
NEXT
6
STORE
END
SELECT
(10/20/30/
40/60/120 sec)
☞
☞
Selects the operation when all extensions in the UCD group do not answer an outside call
via the UCD feature within the length of time programmed in [525] “UCD Ringing Time
before Intercept”. Intercept or Disconnect is available.
Intercept: The call is redirected depending on programs [408]-[410] “Flexible Ringing
Assignment–Day/Night/Lunch” (Intercept Routing – No Answer feature).
Disconnect: The call is disconnected.
Default Intercept
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)
[524] UCD Intercept Mode*
1
2
5
NEXT
4
STORE
END
SELECT
(Intercept/
Disconnect)
☞
*
1
: Required only when the optional OGM/FAX Detection
Card is installed.
PSQX1708ZA-10E.QX 99.10.15 1:06 PM Page 68