Filter
Top Products
System Programming 4-19
4.2 System Programming [109]-[110]
[110] Recall Key Mode
[109] CO Indicator Assignment
Enables or disables an extension which was assigned not to ring in programs [408]-[410]
“Flexible Ringing Assignment” to answer an incoming outside call. The line key indicator
will flash when an outside call is received. If enabled, an extension user can answer the call
by pressing the flashing line key. If disabled, the user cannot answer the call even if they
press the line key.
Default Enable
• The extension must be a proprietary telephone with a line key and indicator.
9
0
1
SELECT
STORE
END
(Enable/
Disable)
NEXT
Assigns the sending of the recall signal mode, MODE 1 or MODE 2, when the RECALL
button on a proprietary telephone is pressed.
MODE 1: The recall signal is sent during the programmed time in [418] “Recall Time”.
MODE 2: The recall signal is sent while the RECALL button is pressed if the time the
RECALL button was pressed is more than the programmed time in [418].
This will be useful to disconnect the current call and make another call
without hanging up. If the time the RECALL button was pressed is less than
the programmed time in [418], the recall signal will be sent during the
programmed time.
Default MODE 1
• Feature Reference
Section 3, Features
Recall
1
SELECT
STORE
END
(MODE1/
MODE2)
NEXT
1
0
!
!
☞
PSQX1708ZA-07E.QX 99.10.15 10:34 AM Page 19