Filter
Top Products
56 / Time savers for making calls
Norstar-PLUS Modular ICS 2.0 System Coordinator Guide P0857846 Issue 02
If you select a line before pressing the autodial button, the call will
go out on the line you have selected instead of the line that is part of
the autodialer programming.
For the M7100 telephone, an external autodialer can only be
programmed using a line and not a line pool.
Using intercom as the line for Autodial
If you press as the line for an external autodial number,
you must include a valid line pool access code or a destination code.
If line pool access codes or destination codes are changed,
remember to reprogram autodial numbers as well.
Displays
Tip -
If you do not include a line selection in an
autodial number, the call will use your prime line (if
you have one).
Continue to enter digits until the number is
complete. Press
or BKSP to
erase an incorrect digit. Press
or
OK when you are finished.
The memory allotted to autodial numbers in
your Norstar system is full.
While programming external Autodial, you
erased the button by pressing
or
OK before entering any digits.
Enter the number you wish to program
(choosing the line first if necessary) exactly
as you would if you were making a call.
Enter the internal telephone number you
wish to program.
You are programming an internal autodial
button and have entered a number that is not
an internal number on your system. Enter a
valid internal number. If the number you are
entering is a destination code, use external
autodial.