Filter
Top Products
Making calls / 49
P0857846 Issue 02 Norstar-PLUS Modular ICS 2.0 System Coordinator Guide
Your installer or customer service representative programs the line
pool access codes and gives each telephone access to a line pool.
Everyone in the office should have a list of the line pool access
codes for the line pools their telephones can use.
Using a line pool to make a call
• Press
.
• Enter a line pool access code.
If you have a free internal line, you can make a call using a line pool
without entering the feature code first.
• Select an internal line (intercom) and dial the line pool access
code.
Programming a memory button with a line pool feature
code
When you program a button with the line pool feature code, you
must enter a line pool access code after the feature code. The
programmed line pool button accesses a specific line pool, not the
line pool feature. See “Programming feature buttons” on page 96 for
more information.
If you program a button with an indicator to access a line pool, when
all the lines in a line pool are busy, the indicator for the line pool
button turns on. The indicator turns off when a line becomes
available.
Changing how you dial your calls
• Press .
• Press or NEXT until the dialing mode you want appears.
Tip -
If no lines are available in the line pool, you
can use Ring Again at the busy tone. You will be
notified when a line in the line pool becomes
available. See “Using Ring Again” on page 52.