Filter
Top Products
First things first
Preparing to use your ET180
xi
Refer to the ActiveSync
TM
software online Help for information on how to use the
software. If at any time, you would like to restart this setup program, simply re-insert the
CD into the CD-ROM drive.
Installing the battery pack
Your ET180 uses a high-density removable and rechargeable 1480 mAH Lithium Ion
polymer battery pack. Refer to the succeeding section for instructions on how to install
the battery pack to your device.
WARNING! There is a risk of fire and burns if the battery pack is handled improperly. DO NOT
disassemble, crush, puncture, short external contacts, or dispose the battery pack in fire or water. DO
NOT attempt to open or service the battery pack. Dispose of used batteries according to local
recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss in instances
when the removable battery pack is removed or completely discharged. This backup
battery cell will support the system for a maximum of 30 minutes only.
NOTE: To enable the internal battery cell to provide backup power supply, charge your device,
without the main battery pack, for at least four (4) hours for a minimum capacity of 30 minutes of
backup power supply. To achieve it's full capacity of ____ backup power supply, charge it in the same
way for at least 14 hours.
For information on conserving power consumption to make your battery pack last longer,
refer to page 109.
To install the battery pack
1 Align the battery marker on the battery pack with the one located on the device.
2 Slide in the battery pack into the battery bay until it clicks into place.
To uninstall the battery pack
1 If the device is on, press the power button to turn it off.
Wait for five (5) seconds to allow the device to completely enter sleep mode.
2 Press down the battery release switch, then
3 Slide out the battery pack from its bay.