Filter
Top Products
5 - 2 Rev A
8/6/08
Dolphin® Power Tools User’s Guide
Disabling ScanWedge
Navigate to the Power Tools Main Window (see page 1-2) and tap the ScanWedge icon again.
OR
Select Exit on the Command Bar Menu (page 5-1).
Modifying the ScanWedge Configuration File
When ScanWedge is installed, a ScanWedge.exm file is inserted in the \IPSM folder. This file specifies
configuration parameters for ScanWedge and must be located in the \IPSM directory. Do not move
ScanWedge.exm!
Use EZConfig Editor on the workstation to modify ScanWedge.exm. For more information, see Working
with Open EXM Files on page 2-7.
ScanWedge.exm Sections
Basic Values
In each section, the following values apply (unless otherwise specified in the tables below):
0 = Disable
1 = Enable
Section Description See Page
Settings Programs general settings for ScanWedge. 5-3
Comm Specifies how the serial (RS-232) port interfaces with ScanWedge. 5-6
Decode Specifies how the decoder/scanner interfaces with ScanWedge. 5-8
Centering Defines the centering window for scanning bar codes when ScanWedge is
interfacing with the decoder.
5-11
Formatting Defines data formatting functionality. 5-12
Symbologies Defines the symbologies that the scanner can decode and send to
ScanWedge.
5-17
VK Mapping Defines the virtual key sent to ScanWedge for any decoded ASCII character. 5-20