Filter
Top Products
9-73
Cisco 6400 Service Connection Manager User Guide
OL-0569-01
Chapter 9 Service/Subscriber Provisioning
Subscriber Provisioning
Table 9-2 displays the Cisco 6400 SCM service types and the tabs in the Service/Subscriber Connection
window that should be configured for each service type.
To connect a subscriber to a service instance, follow these steps:
Step 1 Select the Cisco 6400 UAC, Subscriber, Connect option from an NSP card.
The Service/Subscriber Connection window (shown in Figure 9-91) appears. See the
“Service/Subscriber Connection Window” section on page 10-60 for further details on the parameters
displayed.
Table 9-2 Connecting a Subscriber to a Service Instance
Cisco 6400
Service Type Connection Details Tab
Connect To Single Domain
Tab
Connect to
Multi-Domain Tab
Pure ATM
Switching
Service
Configure the parameters
displayed in the Connection
Parameters and Internal
NSP, NRP PVC panels for
all service types, as
required.
Configure the parameters
displayed, asrequired for all
service types. ClickConnect
when required.
Not required
PPPoA Single
Domain
Not required
L2TP Not required
RFC1483
Routing
Not required
RFC1483
Bridging
Not required
RFC1483 IRB Not required
IP Uplink Configure the
parameters displayed,
as required. Click
Connect when
required.