Filter
Top Products
9-47
Cisco 6400 Service Connection Manager User Guide
OL-0569-01
Chapter 9 Service/Subscriber Provisioning
Service Provisioning
Now create the required entries in the IP Routing Table:
NRP(config)#ip route <Dest IP Address> 255.255.255.255 atm0/0/0.<Sub-Interface Number>
where,
<Dest IP Address> is as configured previously
<Sub-Interface Number> is as configured previously.
Configuring and Commissioning an L2TP Service Instance
To configure and commission an L2TP service instance, follow these steps:
Step 1 Select the Cisco 6400 UAC, Service, Configure L2TP Service option from a Site, Shelf, Chassis, or
service instance object. The L2TP Service Configuration window appears (see Figure 9-60).
Figure 9-60 L2TP Service Configuration Window (PPPoA-SD L2TP Configuration Tab)
See the “Configuration Tab” section on page 10-29 for details on the parameters displayed.
Step 2 Select the appropriate Cisco 6400 and L2TP Service from the lists displayed on the left side of the
window.
Only the L2TP service instance objects (for the selected chassis) are displayed in the L2TP Services
list. Service instances for other service types are listed in their appropriate Service Configuration
windows. For example, IP Uplink service instance objects are displayed in the IP Uplink Configuration
window. The L2TP Services list is empty when no L2TP service instances have been created. See the
“Creating a Service Instance” section on page 9-36 for details on how to create a service instance.
Note Proceed to the “Configuring the L2TP Service Parameters” section on page 9-48
when you are not applying a service profile.
41555