Filter
Top Products
9-5
Cisco 6400 Service Connection Manager User Guide
OL-0569-01
Chapter 9 Service/Subscriber Provisioning
Defining Policies For Service Provisioning
The PPPoA-SD Service Profile Configuration window reappears with the new profile name displayed
in the PPPoA-SD Service Profiles list at left side of the window (see Figure 9-5).
Figure 9-5 PPPoA-SD Service Profile Configuration Window (Configuration Tab)
Note Select the Copy and Copy Page Configuration options in the Edit menu to cut
and paste between different profiles. This is useful when you wish to copy profile
information from one to the next.
Step 4 Configure the parameters in the PPP Session Termination Parameters panel, as required. The PPP
Session Termination Parameters describe the PPP characteristics used to terminate the incoming PPP
traffic. You should set the parameters appropriate to your network topology and services offered.
Note You can apply an existing profile to a new profile to save time when configuring
new profiles. Select the Apply Profile option from the Edit menu and then select
the existing profile you wish to apply from the profiles listed. The configuration
settings are copied from the existing profile to the new profile. The settings copied
appear in blue.
Step 5 Enter values for the Lower and Higher IP Addresses into the IP Address Pool panel, as required. The
IP Address Pool set the range of IP addresses available to a subscriber.
Note If you select to enable the Peer DHCP option, it appears that you are using an
external DHCP Server for IP address allocation, and values entered into the IP
Address Pool panel are grayed out and ignored.