Filter
Top Products
9-40
Cisco 6400 Service Connection Manager User Guide
OL-0569-01
Chapter 9 Service/Subscriber Provisioning
Service Provisioning
Configuring and Commissioning a Service Instance
After you create the service instance object, you should configure and then commission the service
instance from the appropriate Service Configuration window. The service instance object can be
configured in two ways:
• By applying an appropriate service profile and then manually configuring each of the remaining
parameter in that service instance.
• By manually configuring each parameter in the service instance.
This section describes how launch the appropriate Service Configuration window, apply a service
profile (if required), configure the remaining parameters, and then commission the service instance for
each ofthe available Cisco 6400 SCM services. Figure 9-52 displays a typical workflow for configuring
and then commissioning a service instance.
Figure 9-52 Configuring and Commissioning a Service Instance
Apply an existing
Service Profile to a
Service Instance
Configure an
Appropriate
Service Instance
For example, launch the
ATM Service Configuration
window to configure a
Pure ATM service.
Click the
Commission Service
button
Click the Commission
Service button to save the
configuration and "roll"
the service onto the 6400
UAC hardware.
Apply an existing
profile (if required).
It is not possible to create
and apply a profile to
a Pure ATM service.
Launch the
appropriate Service
Configuration Window
Configure the remaining
parameters manually
or configure all of the
parameters manually
(if you did not apply a
service profile).
41808