Filter
Top Products
D-4
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Appendix D System Messages and Access Point LED Patterns
Using Client Reason and Status Codes in Trap Logs
Using Client Reason and Status Codes in Trap Logs
The WCS Clients > Detail page lists the reason and status codes that you are likely to encounter when
reviewing the trap logs. Table D-2 lists client reason codes and descriptions. Table y lists client status
codes and descriptions.
Client Reason Codes
This table lists client reason codes.
SENSED_TEMPERATURE_LOW Check room temperature and/or other reasons for
low temperature.
TEMPERATURE_SENSOR_FAILURE Replace temperature sensor ASAP.
TEMPERATURE_SENSOR_CLEAR Temperature sensor is operational.
POE_CONTROLLER_FAILURE Check ports — possible serious failure detected.
MAX_ROGUE_COUNT_EXCEEDED The current number of active rogue access points
has exceeded system threshold.
SWITCH_UP Controller is responding to SNMP polls.
SWITCH_DOWN Controller is not responding to SNMP polls, check
controller and SNMP settings.
RADIUS_SERVERS_FAILED Check network connectivity between RADIUS
and the controller.
CONFIG_SAVED Running configuration has been saved to flash -
will be active after reboot.
MULTIPLE_USERS Another user with the same username has logged
in.
FAN_FAILURE Monitor Cisco Wireless LAN Controller
temperature to avoid overheating.
POWER_SUPPLY_CHANGE Check for power-supply malfunction.
COLD_START Cisco Wireless LAN Controller may have been
rebooted.
WARM_START Cisco Wireless LAN Controller may have been
rebooted.
Table D-1 System Messages and Descriptions (continued)
Error Message Description
Table D-2 Client Reason Code Descriptions and Meanings
Client
Reason
Code Description Meaning
0 noReasonCode Normal operation.
1 unspecifiedReason Client associated but no longer authorized.