Filter
Top Products
9-16
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 9 Configuring Radio Resource Management
Configuring Dynamic RRM
Using the GUI to Configure Dynamic RRM
Follow these steps to configure dynamic RRM parameters using the GUI.
Step 1 Access the Global Parameters > Auto RF page (see Figure 9-4).
Note Click Set to Factory Default at the bottom of the page if you want to return all of the controller’s
RRM parameters to their factory default values.
Step 2 Table 9-1 lists and describes the configurable RRM parameters. Follow the instructions in the table to
make any desired changes.
Table 9-1 RRM Parameters
Parameter Description
RF Group
Group Mode Determines whether the controller participates in an RF group.
Options:Enabled or Disabled
Default: Enabled
Group Mode Description
Enabled The controller automatically forms an RF group with
other controllers. The group dynamically elects a leader
to optimize RRM parameter settings for the group.
Disabled The controller does not participate in automatic RF
grouping. Rather, it optimizes its own access point
parameters.
Note Cisco recommends that controllers participate in automatic RF
grouping. However, you can disable this feature if necessary by
unchecking the check box. Note also, however, that you
override dynamic RRM settings without disabling automatic
RF group participation. See the “Overriding Dynamic RRM”
section on page 9-23 for instructions.