Filter
Top Products
9-7
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 9 Configuring Radio Resource Management
Configuring an RF Group
Using the GUI to Configure an RF Group
Follow these steps to create an RF group using the GUI.
Step 1 Click Controller > General to access the General page (see Figure 9-1).
Figure 9-1 General Page
Step 2
Enter a name for the RF group in the RF-Network Name field. The name can contain up to 19 ASCII
characters.
Step 3 Click Save Configuration to save your changes.
Step 4 Repeat this procedure for each controller that you want to include in the RF group.