Filter
Top Products
Automatic Tries to Route 0 (Day)
Sets the number of times the Attendant will automatically
transfer a caller to Route 0—when the caller does not dial
a route or extension during the Day, Night, or Transfer Fail
announcement—before the Attendant hangs up (during
business hours).
DIAL
[
★
] [
2
] [
9
] [
0
] [
6
]
DIAL
Number of transfer attempts
Valid settings = 1–20 attempts
Factory setting = 3 attempts
DIAL
[
#
]
Automatic Tries to Route 0 (Night)
Sets the number of times the Attendant will automatically
transfer a caller to Route 0—when the caller does not dial
a route or extension during the Day, Night, or Transfer Fail
announcement—before the Attendant hangs up (after
business hours).
DIAL
[
★
] [
2
] [
9
] [
0
] [
7
]
DIAL
Number of transfer attempts
Valid settings = 1–20 attempts
Factory setting = 3 attempts
DIAL
[
#
]
Security Code
Identifies a code (1–6 digits in length) that must be
entered in order to program the Attendant. The default
security code is 789.
To change the security code:
DIAL
[
★
] [
6
]
DIAL
New code (1–6 digits in length)
DIAL
[
#
]
DIAL New code again
DIAL
[
# ] to confirm new code
A two-beep confirmation tone sounds. Be sure
to remember the new security code. If you
forget it, you will need to reprogram all
Attendant settings (see "Lost Security Code" in
Appendix B).
IMPORTANT: Immediately write down the
security code and keep it in a safe place. If you
lose it, you will not be able to change your
announcements or do any other programming
until you call the Helpline.
Installation and Programming 2-9