Filter
Top Products
36 AastraLink RP System Administrator Guide
Voice Services
5. Click Next, and select the properties of the analog service lines connected to the
AastraLink RP 540 Gateway. Enter a description for each line, such as the local
phone number and area code. If you want to block outbound calls through a phone
line, check the Block Outbound Calls box for that line.
6. Click Next to choose the prefix used to access analog service.
Note: If only analog service is configured, only the prefix 9 is available. If both
analog and VoIP services are configured, you can select which uses the prefix 9
and which uses the prefix 8.
7. Click Next and enter a name for your gateway. Ensure that the name you choose
distinguishes the AastraLink RO 540 Gateway from others on the network.
8. Click Finish to complete configuration of your analog voice service.
Adding VoIP Phone Services
To set up a VoIP internet service, you can enter your account information directly into
the Response Point Administrator software.
If you have VoIP service that comes with hardware, the digital VoIP signal is likely
being changed to an analog signal by the hardware. In this case Response Point
considers your VoIP service analog, and cannot add it in the same manner.
Note: Once VoIP service is connected through the AastraLink RP Solution, you must
dial 8 or 9 (whichever you select) to call external numbers through the VoIP service.