Filter
Top Products
AastraLink RP System Administrator Guide 15
Response Point Administrator
Starting Administrator
The Administrator software walks you through setting up and configuring your
AastraLink RP Solution. Once you have installed the software on the system
administrator’s computer you are ready to start the system.
To start the Administrator software and configure your system, do the following.
1. Select Start > Programs > Microsoft Response Point Administrator. The
Important Notice screen opens.
2. Review the emergency considerations listed and click OK. The Select the base
unit screen opens.
Note: If no base units are listed, ensure your base unit is turned on and wait 30
seconds for the list to refresh. If it is still not detected see Auto-Discovery
Troubleshooting on page 70 of this guide.
3. Choose your base unit. If more than one is shown, check the MAC address on the
bottom sticker on your base unit. The first time you connect, a security screen
opens.
4. Confirm that the correct MAC address for your base unit is displayed, and click
Yes to continue. A security warning screen opens.
5. Click Ye s to accept the security certificate.
Aastra