Filter
Top Products
Sample Configuration Scripts 61
servers with which it communicates.
To accomplish this, it is necessary to carry out several steps including
stopping VCX services.If certain parameters are changed, it may also be
necessary to discontinue any replication which may be occurring with other
servers. Therefore, this utility should only be run on a system which is
not in active use.
When reconfiguration using this utility is complete, additional steps may
be required in order to finish the reconfiguration process, bring services
back on-line, re-establish replication if it was dropped, and restore full
telephony operations. Consult the VCX documentation for assistance.
Do you wish to reconfigure the system at this time? [no] :yes
Starting reconfiguration.
---------------------- Preparing For Reconfiguration ----------------------
Do you want to change this system's networking configuration? Answer 'yes'
if you want to modify the system's IP addresses, default gateways, or
hostname. If you say 'yes' here, replication will be dropped if it is in
use.
Note: If you are *only* changing the system's NTP, DNS, or timezone
configuration, you can use 'vcx-config-network' instead of
'vcx-reconfigure'.
Do you want to change any networking configuration? [no] :yes
Enter yes to configure the network parameters. Otherwise, press the
Enter or Return key to accept the default answer, skip the network
configuration section and proceed with the other configuration steps.
---------------------------------------------------------------------------
------------ Welcome to the VCX Network Reconfiguration Wizard ------------
---------------------------------------------------------------------------
This wizard reconfigures networking and related services. The current
values of networking parameters will be displayed and you will be able to
make any changes necessary.
-------------------------- Configuring Hostname ---------------------------
Enter system hostname : vcxpri