Filter
Top Products
56 APPENDIX C: SAMPLE CONFIGURATION SCRIPTS
Configure networking now? [yes] :
Press the Enter or Return key to accept the default answer and proceed
with the network configuration.
-------------------------- Configuring Hostname ---------------------------
Enter system hostname : vcxpri
VCX Connect servers have factory configured default hostnames (vcxpri
and vcxsec). You can change these hostnames if you want, but changes
are not required.
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address : 192.168.1.190
Network Subnet Mask : 255.255.255.0
Default Gateway Address : 192.168.1.254
Change the IP Address, Network Subnet Mask and Default Gateway
Address values to conform to the network segment on which the server
will reside. To change a value, use the backspace key to delete the current
value, and then enter the new value in the same format.
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server :
Secondary DNS Server :
Tertiary DNS Server : 0.0.0.0
Enter up to three IP addresses, one for each DNS server that you want the
VCX Connect server to know about.
----------------------- Configuring DNS Search Path -----------------------
Press Enter to leave the current path unchanged, or specify
a new search path, with spaces separating each entry.
DNS Search Path : localdomain
Replace this string with the search path appropriate for your company
and the network segment on which the VCX Connect server will reside.
For example, 3Com Corporation uses the search path ne.3com.com for
servers that are located in the New England (ne) area of the US.
-------------------- Configuring Network Time Protocol --------------------
Enter NTP servers one at a time. When done, enter a blank value or 0.0.0.0.
If your organization or ISP does not have an NTP server, consider using the
public NTP servers provided by pool.ntp.org; see http://www.pool.ntp.org