Filter
Top Products
24 CHAPTER 2: VCX™ CONNECT SERVER INSTALLATION
2 Connect a PC to the same hub and:
a Set the IP address of the PC to 192.168.1.180.
b Set the subnet mask to 255.255.255.0
You do not need to configure a default gateway IP address.
3 Start the primary VCX Connect server and wait for approximately 5
minutes for the boot process to be completed.
4 Using one of the connection methods outlined in “Accessing a
VCX Connect Server” on page 14, access the primary server and log in to
the root account.
Primary Server IP Address: 192.168.1.190
Default Password (root account): pvadmin
CAUTION: 3Com strongly recommends that, for security reasons,
customers change the default passwords on these VCX accounts:
■ app
■ cworks
■ oracle
■ root
■ tomcat
■ vcx
Instructions on how to change these account passwords are found later
in this section. See “Changing Default Passwords”
on page 26.
5 Run the vcx-config-network -wizard command and change the IP
address, subnet mask, and default gateway address of the primary VCX
Connect server to correspond to the network location in which you
intend to install the server.
Configuring the Media Gateways
For a VCX Connect 100 server, the media gateways are located within the
same chassis as the VCX Connect server. Use this default IP address to
access the media gateways in the VCX Connect servers:
■ Primary VCX Connect 100 Server Gateways: 192.168.1.200