Filter
Top Products
Sample Configuration Scripts 59
Next, the script prints a summary of the configuration parameters that
you have entered or selected and provides you with the opportunity to
review them. If you notice anything that needs to be changed, you can
answer no to the next prompt and the script will be executed again,
allowing you make any changes that you want.
The sample summary shown next contains changes that were made to
the default values for a primary VCX Connect server configured to run in
one of 3Com’s testing labs.
-------------------------- CONFIGURATION SUMMARY --------------------------
Hostname: vcxpri
IP Interfaces: Device IP Address Network Mask Default Gateway
eth0 10.230.143.24 255.255.255.0 10.230.143.1
DNS Servers: 151.104.25.103
205.142.126.139
Search Domains: ne.3com.com
NTP Servers: 0.pool.ntp.org
1.pool.ntp.org
2.pool.ntp.org
Time Zone: America/New_York
---------------------------------------------------------------------------
Is all of the above information correct? [yes] :
Press the Enter or Return key to accept the data as displayed. The script
then continues with the network configuration and prints the messages
that are shown next.
---------------------------------------------------------------------------
Please wait while the wizard completes.
Saving configuration...Done.
Restarting network services to apply changes...
Shutting down interface eth0: [ OK ]
Shutting down loopback interface: [ OK ]
Setting network parameters: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface bond0: [ OK ]
Bringing up interface eth0: [ OK ]
Shutting down ntpd: [ OK ]
ntpd: Synchronizing with time server: [FAILED]
The server is not connected to the network at this point, and does not
have access to the configured NTP time servers. After you move the