Filter
Top Products
Press the [REMOVE] key within 3-sec-
onds to confirm the Rests All function.
The LCD will display:
CARE AND MAINTENANCE
Place your phone in a location where its
cords will be out of the way and where it
is not likely to be knocked to the floor.
To clean, use a soft cloth, dampened in
mild detergent. Never use abrasives or
solvents and never spray cleaners direct-
ly onto the telephone.
RADIO FREQUENCY INTERFER-
ENCE
WARNING! This equipment generates,
uses and can radiate radio frequency
energy and if not connected and operat-
ed in accordance with the Owner’s
Manual, may cause interference to radio
communications. It has been tested and
found to comply with the limits for a
Class A computing device pursuant to
Subpart J of Part 15 of the FCC Rules
which are designed to provide reason-
able protection against such interference
when operated in a commercial environ-
ment. Operation of this equipment in a
residential area is likely to cause interfer-
ence in which case the user at his own
expense will be required to take whatev-
er measures may be required to correct
the interference.
PROBLEMS YOU CAN SOLVE
STATION IS RINGING CONTINUOUSLY
Make sure the station number is dif-
ferent than the other stations being
used.
CANNOT DISPLAY THE CALLER ID
RECORDS
Make sure the station is on-hook and
idle.
ARE INTERCOM, LINE STATUS, AUTO-
ANSWER, PRIVACY, OR AUTO-LINE
SELECTION INOPERABLE?
1. Check if Lines 1 and 2 are cross-
wired in the wall jack.
2. See if you may have installed your 2-
line adapter incorrectly.
3. Be sure all NSQ412 stations in the
system are connected to Line 1 and
disconnect all non-system telephones
from Line 1.
4. Check the station programmable
codes.
5. Be sure the length of cable between
stations does not exceed 600 feet.
6. Check that all phone lines are correct-
ly connected to each station (every
Line 1 is connected to the appropriate
CO line, every Line 2 is connected to
the appropriate CO line, and so on).
7. Remove all RFI filters from the sys-
tem wiring, you may also need to
contact your telephone company to
have any RFI filters removed from the
company side of the connection.
IS YOUR TELEPHONE INOPERABLE?
1. Check all connections to be sure they
are securely in place.
2. Reinitialize the telephone by momen-
tarily unplugging the a. c. adapter.
3. Make sure the a. c. adapter has
power at the wall outlet.
NSQ412 Four-Line Caller ID Telephone Owner’s Manual 50
Reset!