Filter
Top Products
NSQ412 Four-Line Caller ID Telephone Owner’s Manual 35
Press the [REMOVE] key to begin delet-
ing the record. The LCD will display:
Press the [REMOVE] key again within 3-
seconds to confirm the deletion. The
LCD will display:
After approximately 5-seconds, the LCD
will return to the CID Summary screen.
Dialing a Caller ID Record
To dial a telephone number from the
Caller’s List, display the record to be
called. Press the Center of the [JOG]
knob. The telephone will go off-hook on
an available CO Line in the previous
mode (handsfree or headset) and dial
the number.
or
Pick up the handset. The telephone will
go off-hook on an available CO Line and
dial the number.
or
To select a desired CO Line and dial,
while viewing the entry, press the desired
[CO Line] key.
In all cases for example, the LCD will
display:
NOTE
: Be sure to read the section Area
Code Programming to make sure the
CID number is stored and dialed in the
correct format (7-digit, 10 digit or 11-digit
dialing). When the calling number does
not originate from any of the pro-
grammed area codes, the LCD will dial a
1 + the entire number when the calling
number is 10-digits or longer.
Storing a Caller ID Record
To save a record from the Caller’s List
into the Directory or a Speed Dial loca-
tion, display the record to be saved. For
example, the LCD will display:
Press the [RELEASE] key to quit the
Caller’s List. Press the [DIRECTORY]
key. The LCD will display:
Press the [SAVE] key to start to enter the
name. The LCD will display:
Press the [CID LIST] to copy the Caller
ID name and number from the Caller List
to the display. For example, the LCD will
display:
12/27 02:33P
CL#174 L2
BOB JONES
REMOVE:remove?
03/25 03:42P
CL#132 L1
SALLY PETERS
5556767
SALLY PETERS
5556767
SAVE:save?
CL#174
Removed!
1234567
00:01
CID:100/198
DIRECTORY
<>:select
Public/Private
(Enter name)
SAVE:save?