Filter
Top Products
Press the [SAVE] key to store the min-
utes setting. The unit will then enter the
AM/PM mode. Rotate the [JOG] knob to
select the AM/PM. The LCD will display:
or
Press the [SAVE] key to store the
AM/PM setting. The LCD will display:
After approximately five seconds, the dis-
play will return to the highest level of the
current setting.
Programming the Station Number
Each station must have a different station
number. If two stations have the same
number, one will continuously emit a ring
tone after initializing. To program the
Extension Number, enter the program-
ming mode and turn the [JOG] knob until
the display shows EXTENSION NO. The
LCD will display:
Press the NAVIGATION [>] key to begin
selecting the Extension Number. NOTE
:
The default extension number is 11.
Rotate the [JOG] knob to select the
extension number. The LCD will display:
•
•
Press the [SAVE] key to accept the set-
ting. The LCD will display:
After approximately five seconds, the dis-
play will return to the highest level of the
current setting.
Message Waiting Indicator
Programming
The MSGW Waiting indicators may be
manually turned on or off. To program
the MSGW indicators for CO Lines, enter
the programming mode and turn the
[JOG] knob until the display shows
MSGW ON/OFF. The LCD will display:
MINUTES
12/31 12:59
A
Turn Dial
SAVE:save?
EXTENSION NO
Turn Dial
>: enter
EXTENSION NO
=22
Programmed!
MSGW ON/OFF
Turn Dial
>: enter
EXTENSION NO
=11
Turn Dial
SAVE:save?
EXTENSION NO
=22
Turn Dial
SAVE:save?
AM/PM
12/31 12:59A
Turn Dial
SAVE:save?
AM/PM
12/31 12:59P
Turn Dial
SAVE:save?
AM/PM
12/31 12:59P
Programmed!
NSQ412 Four-Line Caller ID Telephone Owner’s Manual 41