Filter
Top Products
NSQ412 Four-Line Caller ID Telephone Owner’s Manual 47
Tone or Pulse Dial Programming
The station can be set to dial in Tone or
Pulse. To program the Tone/Pulse dial,
enter the programming mode and turn
the [JOG] knob until the display shows
TONE/PULSE. The LCD will display:
Press the NAVIGATION [>] key to begin
programming the Tone/Pulse dialing.
Rotate the [JOG] knob to change the
selection. The LCD will display:
or
Press the [SAVE] key to confirm the
selection. The LCD will display:
After approximately five seconds, the dis-
play will return to the highest level of the
current setting.
Flash Time Programming
The amount of time the station opens the
telephone line when the [FLASH] key is
pressed can be changed. To program the
Flash Time, enter the programming mode
and turn the [JOG] knob until the display
shows FLASH TIME. The LCD will dis-
play:
Press the NAVIGATION [>] key to begin
programming the Flash Time. Rotate the
[JOG] knob to change the selection. The
LCD will display:
•
•
Press the [SAVE] key to confirm the set-
ting. The LCD will display:
After approximately five seconds, the dis-
play will return to the highest level of the
current setting.
TONE/PULSE
Turn Dial
>: enter
FLASH TIME
Turn Dial
>: enter
FLASH TIME
= 0.1 sec
Turn Dial
SAVE:save?
FLASH TIME
= 1.2 sec
Turn Dial
SAVE:save?
FLASH TIME
= 1.2 sec
Programmed!
TONE/PULSE
= Tone
Turn Dial
SAVE:save?
TONE/PULSE
= Pulse
Turn Dial
SAVE:save?
TONE/PULSE
= Pulse
Programmed!