Filter
Top Products
IPedge
Feature Operations
52 TOSHIBA
IPedge UG 06/11
Setting DND for
Another Extension
To activate DND for another extension
• Enter #6191 (hear Entry Tone) + the Primary extension of the remote
extension + the pass code + # (hear Success Tone). This sets DND as if
activated by the Primary extension on the target telephone.
To deactivate DND for another extension
• Enter #6192 (hear Entry Tone) + the Primary extension of the remote
extension + the pass code + # (hear Success Tone). This removes DND
from the target telephone.
To change your DND Pass Code
• Enter #670 (hear Entry Tone) + ext. no. (hear Entry Tone) + old pass
code + # (hear Entry Tone) + new pass code + # (hear Success Tone).
If you activate DND while a call is ringing, the ringing stops. The LED
continues to flash on your telephone and ring on other appearances.
Emergency Call To make an emergency call, dial 911 or Access Code + 911. This
depends on off-hook preference set up for your telephone.
Note: Check with your System Administrator for the Access Code because
this code may be different from the one used to get an outside line.
Emergency
Monitoring Station
Your system may have one IP telephone assigned as an emergency
monitoring station. If your telephone has this assignment, your line LED will
flash green when someone makes a 911 call. When you answer the call, you
can listen in and participate in the conversation. See your System
Administrator for more information on this feature.
Emergency Ringdown If a station remains off-hook for a programmable period, it can be
automatically treated as an Emergency Call and directed to an emergency
destination. The station may have partially dialed a number or have dialed no
digits at all. Each station is programmed with its specific emergency ringdown
destination.
A station number or a group pilot number can be specified as an emergency
ringdown destination. In a private network, the station or pilot number must be
in the same network node.
Language Codes This feature enables you to change the language sent from the Attendant
Console or from a PC. See your System Administrator to find out if your
telephone is programmed with the ability to change languages.
To change the Language Display
• Enter the Change Language access code #495 + the Language Code
(see below).