Filter
Top Products
IPedge
Feature Operations
38 TOSHIBA
IPedge UG 06/11
If the system is set for Verified Account Codes, station users must enter a
specific code when entering the Voluntary Account Code(s) or the code is not
validated for the SMDR call report. This does not affect the call.
Voluntary Account
Codes
There are two ways to dial using a Voluntary Account Code:
Using the Account Code
Button
Note: This requires a Programmable Feature Button to be programmed on
your telephone set with the Account Code feature access code (#46).
1. After accessing a Group Central Office (GCO) line, press the Account
Code button. LCD telephones prompt you to “ENTER ACCOUNT CODE
NOW.”
2. Enter the account code digits. The LCD prompt disappears upon entry of
the first account code digit. After the account code is entered, the time
indicator is restored to the LCD.
3. If your station is set for Verified Account Codes, you hear a confirmation
tone when the code is valid. If the code is invalid, you hear two short
tones.
4. Enter the Account Code. Your conversation is not interrupted.
Using Access Codes Note: It’s a good idea to warn the other party that you will be disconnected
momentarily when you enter the access code. Once the code is
entered, you will be connected again.
1. After accessing a GCO line, press Cnf/Trn. Once you press Cnf/Trn,
your call is interrupted; you and the other party cannot hear each other.
You will hear feature dial tone.
2. Dial #46. LCD telephones prompt you to “ENTER ACCOUNT CODE
NOW.”
3. Enter the account code digits. The prompt disappears upon entry of the
first account code digit. After the account code is entered, the connection
is restored and the LCD shows the time.