Filter
Top Products
42 System Telephone Features Sipura SPA-841 Telephone User Guide
620-05600270
3. Press the select soft key below the phone display.
4. Use the up and down scroll keys to highlight view the assigned speed dials.
5. Press the cancel soft key twice to revert to the main display.
Deleting a Speed Dial Number
You can add speed dials from your directory entries. To add one of your directory
entries to a speed dial, do the following:
1. Press the “ ” button. On the phone display, a list of four options appear.
2. Use the scroll down arrow key to highlight option number 2, Speed Dial .
3. Press the select soft key below the phone display.
4. Use the up and down scroll keys to highlight speed dial to be assigned.
5. Press one of the following soft keys:
• edit - to add or edit the selected speed dial information
• cancel - to exit the speed dial list
6. If you selected edit, then press the More ( ) button once.
7. Press the clear soft key to clear the speed dial.
8. Press the More ( ) button three times until you see the ok soft key.
9. Press the ok soft key to save the changes.
10. After you have made the desired edits, press the cancel soft key twice to
revert to the main display.
Star Codes
The codes used by analog DTMF users to activate features (commonly referred to
as "star codes") are also supported for IP phones. By pressing the pound or star
button on the telephone and entering the proper code, you can make use of these
codes for feature use.
The feature must be active at your phone for it to be accessed from the star codes
(that is, you can't use features that aren't turned on) and some caution should be
used when activating features from star codes, since they may not be reflected in
display messages or lamp activity on the telephone.
NOTE:
This table lists the feature codes that are the default values for your
phone system at the time of installation. They may be changed by your system
administrator to meet the needs of your company. Any list of feature codes
given to you by your system administrator should be used in place of the codes
listed here.