Filter
Top Products
Changing Your Settings 92
Setting a Phone Password
9. Tap the Version Info tab to view the R2VS software version information.
Setting a Phone Password
For more information, refer to "Locking Your i760" on page 24. The password
option allows you to enable or disable a password. The available settings are:
• Simple PIN: This password must be at least four characters in length and can not
contain a simple sequence such as: 000, 1111, or 1234.
• Strong alphanumeric: This password must be at least seven characters in length
and contain at least three of the following: uppercase/lowercase letters, numerals,
and punctuation.
When a password is configured, there is a “prompt if device unused” option that
allows a length of time range from 0 minutes - 24 hours. When this option is set, you
can continue to use the i760 until the screen turns off due to inactivity. If the device
is inactive for a greater amount of time than specified in this setting, a password
must be entered when you turn the device back on.
To set the password:
1. From the Today screen, tap Start ( ) located in the upper left corner of
the screen.
2. Tap Settings ().
3. Tap the Personal tab.
4. Tap Lock ( ).
5. Tap the check box next to Prompt if device unused for.
6. Tap the Minutes drop down menu and select the amount of unused time
required before you are prompted for a password if the phone becomes
idle.
7. Tap the Password type box and select either Simple PIN or Strong
alphanumeric.
8. Tap the Password box and use either your QWERTY keypad or keypad to
enter the password you want. Re-enter the password in the Confirm box.
9. Tap , then tap Yes to confirm.
ok