Nortel Networks BM450 Telephone User Manual


 
40 Chapter 4 Software Troubleshooting
NN40160-700NN40160-700
Properties
The Properties tab shows basic line properties. Not all fields apply to all types of lines.
The Properties tab is shown in Figure 10 on page 41.
Pub.
Received #
(Target lines
only)
<digits associated with a
specific target line>
Specify the digits the system will use to identify a call from
the public network to this target line.
A received number cannot be the same as, or be the
start digits, of a line pool access code, a destination
code, the DISA DN or the Auto DN.
If you are configuring auto-answer BRI trunks to map to
target lines, the received number should be the same as
the Network DN supplied by your service provider. The
call will be directed to the prime telephone for the
incoming line if the Network DN is not used.
Priv.
Received #
(Target lines
only)
<digits associated with a
specific target line>
Specify the digits the system will use to identify a call from
the private network to this target line.
A received number cannot be the same as, or be the
start digits, of a line pool access code, a destination
code, the DISA DN or the Auto DN.
If you are configuring auto-answer BRI trunks to map to
target lines, the received number should be the same as
the Network DN supplied by your service provider. The
call will be directed to the prime telephone for the
incoming line if the Network DN is not used.
Distinct ring None
Pattern 2
Pattern 3
Pattern 4
Choose the distinctive ring pattern that you want to assign
to the line. This allows you to provide selective service to
calls with differing answer priorities.
When more than one line with the distinct ring settings rings
at a telephone, the line with the highest priority rings first.
Pattern 4 has the highest ring priority
Pattern 3 has second highest ring priority
Pattern 2 has third highest ring priority
None has the lowest ring priority.
By default, all telephones and lines are set to None.
Table 7 Trunk/Line Data main panel (Sheet 3 of 3)
Attribute Value Description