Filter
Top Products
4-9
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-23091-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phones
Network Configuration Menu
Table 4-3 describes the IPv4 configuration menu options.
PC VLAN Allows the phone to interoperate with third-party switches
that do not support a voice VLAN. The Admin VLAN ID
option must be set before you can change this option.
1. Unlock network configuration
options.
2. Make sure the Admin VLAN ID
option is set.
3. Scroll to the PC VLAN option,
press the Edit softkey, and then
enter a new PC VLAN setting.
4. Press the Validate softkey and
then press the Save softkey.
VPN Shows the virtual private network (VPN) Client state:
• Connected
• Not Connected
(Supported only for the Cisco Unified IP Phone 7942G,
and 7962G.)
Display only—Cannot configure.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change
Ta b l e 4-3 IPv4 Configuration Menu Options
Option Description To Change
DHCP Indicates whether the phone has DHCP enabled or
disabled.
When DHCP is enabled, the DHCP server assigns the
phone anIPv4 address. When DHCP is disabled, you
manually assign an IPv4 address to the phone.
1. Unlock network configuration
options.
2. Scroll to the DHCP option and
press the No softkey to disable
DHCP, or press the Yes softkey
to enable DHCP.
3. Press the Save softkey.
IP Address Internet Protocol version 4 (IPv4) address of the phone.
If you assign an IPv4 address with this option, you must
also assign a subnet mask and default router. See
Subnet
Mask and Default Router 1 options in this table.
1. Unlock network configuration
options.
2. Set the DHCP option to No.
3. Scroll to the IP Address option,
press the Edit softkey, and then
enter a new IP Address.
4. Press the Validate softkey and
then press the Save softkey.