Filter
Top Products
5-13
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-23091-01
Chapter 5 Configuring Features, Templates, Services, and Users
Telephony Features Available for the Cisco Unified IP Phone
Intercom Allows users to place and receive intercom calls
using programmable phone buttons. You can
configure intercom line buttons to:
• Directly dial a specific intercom extension.
• Initiate an intercom call and then prompt the
user to enter a valid intercom number.
Note If your user logs into the same phone on a
daily basis using their Cisco Extension
Mobility profile, assign the phone button
template that contains intercom
information to their profile, and assign the
phone as the default intercom device for
the intercom line.
Cisco Unified Communications Manager
Feature and Services Guide,
Intercom.
Join/Select Allows a user to join two or more calls that are on
one line to create a conference call and remain on
the call.
For more information:
• See Configuring Softkey Templates,
page 5-27.
• See Cisco Unified Communications
Manager System Guide,
Cisco Unified IP
Phones.
Join Across
Lines/Select
Allows users to apply the Join feature to calls that
are on multiple phone lines.
For more information:
• See the Configuring Softkey Templates,
page 5-27.
• See Cisco Unified Communications
Manager System Guide,
Cisco Unified IP
Phones.
Line select If this feature is disabled (default), then the ringing
line is selected. When enabled, the primary line is
picked up even if a call is ringing on another line.
The user must manually select the other line.
Note This feature can also be enabled or
disabled for Extension Mobility.
For more information, see the option “Always
use prime line” in the following chapters of
Cisco Unified Communications Manager
Administration Guide:
• Device Profile Configuration
• Common Phone Profile Configuration
• Cisco Unified IP Phone Configuration
Line select for voice
messages
When disabled (default), pressing the Messages
button selects the line that has a voice message. If
more than one line has voice mail, then the first
available line is selected. When enabled, the
primary line is always used to retrieve voice
messages.
Note This feature can also be enabled or
disabled for Extension Mobility.
For more information, see the option “Always
use prime line for voice message” in the
following chapters of Cisco Unified
Communications Manager Administration
Guide:
• Device Profile Configuration
• Common Phone Profile Configuration
• Cisco Unified IP Phone Configuration
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description Configuration Reference