Filter
Top Products
Embedded Voicemail Installation Guide
Page 12 Embedded VoiceMail Installation
50-601067 Issue 5 (20th December 2006) IP Office 4.0
IP 500 Installation
The following instructions detail the process for installing Embedded VoiceMail for an IP500 system.
1. Check that the following requirements have been met.
Hardware:
IP Office 500 control unit. No voice compression channels are required.
Avaya supplied 512MB Memory (Compact Flash) Card.
Configuration:
PC, connected to the IP Office network with the IP Office Manager application installed.
2. Install the Memory Expansion Card
The IP 500 Memory Card is a Type II Compact Flash memory card. Only a card supplied by Avaya can be
used for Embedded VoiceMail. Compact Flash cards from other sources cannot be used for Embedded
VoiceMail.
Switch off the IP Office unit before you insert the memory card.
Warning
You must always switch off the IP Office before you insert or remove a memory card.
Insert the memory card into the C/F TII card slot at the rear of the IP500 control unit. Insert the
card with the memory card label upwards. As you insert the card, the card eject button adjacent to
the slot will come out.
Switch on the IP Office unit.
3. The system can now be configured for Embedded VoiceMail. For more information, see System
Configuration.