Filter
Top Products
Embedded Voicemail Installation Guide
Page 10 Embedded VoiceMail Installation
50-601067 Issue 5 (20th December 2006) IP Office 4.0
IP406 V2 Installation
The following instructions detail the process for installing Embedded VoiceMail for an IP406 V2 system.
1. Check that the following requirements have been met.
Hardware:
IP Office 406 V2 control unit. No voice compression channels are required.
Avaya supplied 512MB Memory (Compact Flash) Card.
Configuration:
PC, connected to the IP Office network with the IP Office Manager application installed.
2. Install the Memory Expansion Card
The IP 406 V2 Memory Card is a Type II Compact Flash memory card. Only a card supplied by Avaya can
be used for Embedded VoiceMail. Compact Flash cards from other sources cannot be used for Embedded
VoiceMail.
Switch off the IP Office unit before you insert the memory card.
Warning
You must always switch off the IP Office before you insert or remove a memory card.
Insert the memory card into the C/F TII card slot on the front of the IP406 V2 control unit. Insert the
card with the memory card label upwards. As you insert the card, the card eject button adjacent to
the slot will come out.
Switch on the IP Office unit.
3. The system can now be configured for Embedded VoiceMail. For more information, see System
Configuration.