Filter
Top Products
Operational Features
5-90 41-001160-01, Rev 00, Release 2.3
IP Phone Administrator Guide
• Custom mode - The Custom mode allows you to configure CFWD for a
specific account or all accounts. You can configure a specific mode (All,
Busy, and/or No Answer) for each account independently or all accounts. On
the 9143i, 51i, and 53i phones, you can set all accounts to ALL On or ALL
Off. On the 9480i, 9480i CT, 55i, 57i, and 57i CT, you can set all accounts to
All On, All Off, or copy the configuration for the account in focus to all other
accounts using a CopytoAll softkey.
The states you can set for Call Forward are All, Busy, No Answer. You can enable
different call forwarding rules/modes independently (for example, you can set
different phone numbers for Busy, All, and NoAns modes and then turn them on/
off individually. The behavior of these states is dependent on the mode (account,
phone, or custom) you configure on the phone.
Reference
For more information about how Call Forwarding works and how you can use it
on the IP Phones, see “Call Forwarding” on page 5-234.
Configuring Call Forward Key Mode
Use the following procedures to set the Call Forward key mode on the IP phones.
Note: If there is only one account configured on the phone, then the
mode setting is ignored and the phone behaves as if the mode was set
to “Phone”.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Call Forward
Key Mode Settings” on page A-122.