Filter
Top Products
Administrator Level Options
3-52 41-001160-01, Rev 00, Releaes 2.3
IP Phone Administrator Guide
PC Port Settings (Port 1)
PC Port VLAN ID VLAN ID VLAN id port 1 Specifies the VLAN ID used to pass
packets through to a PC via Port 1.
Note: If you set the PC Port VLAN
ID (Port 1) to 4095, all untagged
packets are sent to this port. The
following is an example of
configuring the phone on a VLAN
where all untagged packets are sent
to the passthrough port.
Example
You enable tagging on the LAN Port
(VLAN id) as normal but set the PC
Port (VLAN id port 1) to 4095. The
following example sets the phone to
be on VLAN 3 on the LAN Port but
the PC Port is configured as
untagged.
tagging enabled: 1
VLAN id: 3
VLAN id port 1: 4095
For more information, see Chapter
4, “Virtual LAN (optional)” on
page 4-50.
PC Port Priority Priority QoS eth port 1 priority Specifies the priority value used for
passing VLAN packets through to a
PC via Port 1.
For more information, see Chapter
4, “Virtual LAN (optional)” on
page 4-50.
Parameter In
IP Phone UI
Parameter in
Aastra Web UI
Parameters in
Configuration Files
Description