Creating an XML Application
G-78 41-001160-01, Rev 00, Release 2.3
IP Phone Administrator Guide
Attributes/Options to Use with XML Objects
Beep Attribute
(configurable via XML objects, config files, or Aastra Web UI)
You can enable or disable a “Beep”option to indicate a status on the phone using
the Status Message object (AastraIPPhoneStatus), the configuration files, or the
Aastra Web UI.
When the phone receives a status message, the BEEP notifies the user that the
message is displaying. The following attribute in the AastraIPPhoneStatus object
enables/disables the BEEP from being heard:
< AastraIPPhoneStatus Beep="yes|no"> (case sensitive)
This attribute is optional. If notification is required, the attribute must be in the
ROOT. If the BEEP attribute is set to "yes" (i.e. Beep="yes") then it is an
indication to the phone to sound a beep when it receives the object. If the Beep
attribute is set to "no" (i.e. Beep="no") or not present, then the default behavior is
no beep is heard when the object arrives to the phone.
Scroll Delay Option
(configurable via config files and Aastra Web UI only)
The IP phones support a scroll delay option that allows you to set the time delay,
in seconds, between the scrolling of each status message on the phone. The default
time is 5 seconds for each message to display before scrolling to the next message.
You can configure this option via the configuration files or the Aastra Web UI.
Changes are dynamic and apply to the phone immediately.
Note: For enabling/disabling a status message beep using the
configuration files and the Aastra Web UI, see Chapter 5, the section,
“Enabling/Disabling a Beep for Status Message Displays.”.
Note: The value set in the configuration files and Aastra Web UI override
the attribute you specify for the AastraIPPhoneStatus object.
Note: For more information about setting the scroll delay option, see
Chapter 5, the section, “Scroll Delay Option for Status Messages.”