Filter
Top Products
Operational Features
41-001160-00, Rev 01 Release 2.0 5-25
Operational IP Phone Features
Operational IP Phone Features
You can enable or disable the softkey states using the configuration files or the
Aastra Web UI. In the Aastra Web UI, you disable a state by unchecking the box
for that operational state.
In the configuration files, you use the following parameters to enable and disable
operational states:
• softkeyN states
You can enter multiple values (idle, connected, incoming, outgoing, busy) for
the "softkeyN state" parameter. For example:
softkeyN states: idle connected
You must associate the softkeyN state parameter with a specific softkey. In the
following example, the softkeyN states parameter is associated with softkey 12:
softkey12 type: speeddial
softkey12 label: voicemail
softkey12 value *89
softkey12 states: outgoing
Note: The IP phone idle screen condenses the softkeys. So in the
previous example, softkey 12 will appear in position 1 if no other
softkeys are set. A softkey type of "empty" does not display on the idle
screen at all. (For more information about the softkey type of "empty"
see Appendix A, the section, “Softkey Settings for 55i, 57i, 57i CT” on
page A-110.