Filter
Top Products
Advanced Network Settings
4-36 41-001160-00, Rev 01 Release 2.0
IP Phone Administrator Guide
Configuring the IP Phones
.
Configuring VLAN (optional)
Use the following procedures to configure VLAN on the IP phone.
Aastra Web UI
Step Action
1 Click on Advanced Settings->Network->Type of Service,DSCP.
2 Choose a Protocol (SIP, RTP, and/or RTCP), and enter a value from 0 to 63.
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map
the applicable priority to the Protocol setting as shown in the table “DSCP Range/VLAN Priority” on
page 4-36 For more information, see the section “Configuring VLAN (optional)” on page 4-36.
3 Click to save your settings.
Note: The session prompts you to restart the IP phone to apply the configuration settings.
4Select Operation->Reset and click ..
Note: VLAN is disabled by default. When you enable VLAN, the IP
phones use the default settings for each VLAN parameter. You can
change the default settings if required using the following procedure.