Filter
Top Products
Chapter 5 Broadband
FMG3024-D10A / FMG3025-D10A Series User’s Guide
78
Figure 20 Broadband Add/Edit: Routing - IPoE - IPv6 Only
The following table describes the fields in this screen.
Table 7 Broadband Add/Edit: Routing - IPoE
LABEL DESCRIPTION
General
Name Enter a service name of the connection.
Mode Select Routing (default) from the drop-down list box if your ISP give you one
IP address only and you want multiple computers to share an Internet account.
WAN Service Type This field is available only when you select Routing in the Mode field. Select
the method of encapsulation used by your ISP.
• PPP over Ethernet (PPPoE) - PPPoE (Point to Point Protocol over
Ethernet) provides access control and billing functionality in a manner
similar to dial-up services using PPP. Select this if you have a username and
password for Internet access.
• IP over Ethernet - In this type of Internet connection, IP packets are
routed between the Ethernet interface and the WAN interface and then
formatted so that they can be understood in a bridged environment.
IPv6/IPv4 Mode Select IPv4 Only if you want the Device to run IPv4 only.
Select IPv6/IPv4 DualStack to allow the Device to run IPv4 and IPv6 at the
same time.
Select IPv6 Only if you want the Device to run IPv6 only.
VLAN
Enable VLAN Select this to add the VLAN tag (specified below) to the outgoing traffic through
this connection.
Enter 802.1P
Priority
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a
MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this
connection. The greater the number, the higher the priority level.
Enter 802.1Q VLAN
ID
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
IP Address This section is available only when you select Routing in the Mode field and
IPoE in the WAN Service Type field.