Filter
Top Products
79
Cordless Telephone
For assistance, please call: 1-800-211-PANA(7262)
With the base unit
Make sure the base unit is not being used.
1
Press (FUNCTION).
2
Scroll to “Initial setting” by pressing
Ö or Ñ, and press á.
3
Scroll to “Set tel line” by pressing Ö
or Ñ, and press á.
4
Scroll to “Set flash time” by pressing Ö
or Ñ, and press á.
5
Press Ö (Line 1) or Ñ (Line 2) to select
the line.
•The line’s current setting will be displayed.
6
Select the desired time by pressing Ö or
Ñ.
7
Press á (Save).
•A beep sounds.
•To program the other line, start again from step 4.
•To exit the programming mode, press (STOP/EXIT).
•You can exit the programming mode any time by pressing (STOP/EXIT)
.
With the handset
Make sure the base unit and the handset are not being used.
Press (CONF/FUNCTION), and follow steps 2 to 5
of the base unit, using the handset. The display
will then show the following.
Select the desired time by pressing Ö or Ñ,
and press the right soft key ( ).
•You can exit the programming mode any time by
pressing (OFF)
.
SAVE
Set flash time
Line1 :700ms
GF
SAVE
Set dial mode
H
Set flash time
Set line mode
Caller ID edit
H
Set tel line
Set answering
Copy directory
H
Initial setting
---------------
Set flash time
G
=Line1
F
=Line2
Set flash time
Line1 :700ms
GF
H
=Save
LINE1 LINE2