Filter
Top Products
19
Preparation
For assistance, please call: 1-800-211-PANA(7262)
•
You can go back to the previous display by pressing Ü except when entering characters
or numbers. To return to the main menu from the sub-menu I or sub-menu II, press Ü.
•You can exit the programming mode any time by pressing (
STOP/EXIT
).
•If you do not press any buttons for 60 seconds, the base unit will exit the
programming mode.
•If the unit detects a problem, an error message will be displayed (p. 106).
Base unit function menu table
You can use the following functions to customize your unit. After pressing
(FUNCTION), the main menu is displayed. Most items in the main menu
have a sub-menu I. The sub-menu I is shown after selecting the item in
the main menu. If the sub-menu I item has the sub-menu II, it will be
displayed after selecting that sub-menu I item. See the corresponding
pages for function details.
*
“
Set dial mode
”, “
Set flash time
” and “
Set line mode
” can be programmed
with either the base unit or handset. You do not need to program those items both on
the base unit and handset.
Save directory
p. 52
p. 20
Ringer setting
Copy directory
Initial setting
p. 25
p. 78
p. 81
Ringer volume
Ringer tone
Incoming call
Date and time
p. 60
Copy 1 item
p. 62
Copy all items
p. 26
LCD contrast
p. 72
Room monitor
p. 46
Caller ID edit
Set tel line
p. 80
Line selection
p. 21*
Set dial mode
p. 79*
Set flash time
p. 22*
Set line mode
Set answering
p. 84
Answer line
p. 28
Greeting record
p. 29
Greeting check
p. 30
Number of rings
p. 27
Recording time
p. 95
Remote code
p. 83
Set mailbox2&3
p. 85
Call monitoring
Main menu Sub-menu I Sub-menu II