Filter
Top Products
21
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Dialing Mode
If you have touch tone service, set to “Tone”. If rotary or pulse service is
used, set to “Pulse” using either the base unit or handset. Your phone
comes from the factory set to “Tone”.
With the base unit
Make sure the base unit is not being used.
1
Press (FUNCTION).
2
Scroll to “Initial setting” by pressing
Ö or Ñ, and press á.
3
Scroll to “Set tel line” by pressing Ö
or Ñ, and press á.
4
Scroll to “Set dial mode” by pressing Ö
or Ñ.
5
Press á.
•The current setting is displayed.
6
Select “Pulse” or “Tone” by pressing Ö or
Ñ.
7
Press á (Save).
•A beep sounds.
•To exit the programming mode, press
(STOP/EXIT).
•You can exit the programming mode any time by pressing (STOP/EXIT)
.
Caller ID edit
H
Set tel line
Set answering
---------------
H
Save directory
Ringer setting
Copy directory
H
Initial setting
---------------
Line selection
H
Set dial mode
Set flash time
Set dial mode
:Tone
GF
H
=Save
Set dial mode
:Pulse
GF
H
=Save
Set dial mode
:Pulse
With the handset
Make sure the base unit and the handset are not being used.
Press (CONF/FUNCTION), and follow steps 2 to 5
of the base unit, using the handset. The display
will then show the following.
Select “Pulse” or “Tone” by pressing Ö or Ñ,
and press the right soft key ( ).
•You can exit the programming mode any time by pressing (OFF).
SAVE
Set dial mode
:Tone
GF
SAVELINE1 LINE2