Filter
Top Products
Programmable Settings
20
Date and Time
Voice Day/Time Stamp: During playback, a synthesized voice will
announce the day and time that each message was recorded.
Use the base unit. Make sure the base unit is not being used.
1
Press (FUNCTION).
2
Scroll to “Date and time” by pressing Ö
or Ñ.
3
Press á.
4
#Enter the year, and month and day using
4-digit numbers. (Ex. To set Apr. 7, 2002,
enter “2002” and “0407”.)
$Enter the time (hour and minute) using
a 4-digit number. (Ex. To set 9:30, enter
“0930”.)
•If you enter a wrong number, press Ü or á to
move the cursor to the incorrect number. Enter
the correct number.
5
Select “AM” or “PM” by pressing (*).
6
Press Ö (Save).
•
A beep sounds and the clock starts working.
•If 3 beeps sound, the setting is not
correct. Start again from step 4.
•To exit the programming mode, press
(STOP/EXIT)
.
•You can exit the programming mode any time by pressing (STOP/EXIT).
•When entering the time in step 4, you cannot enter numbers greater than 12.
Do not use military time. (To set 13:00 hours, enter “0100”, and select “PM” by
pressing (*).)
Date:2002.04.07
Time:09:30 PM
IH
0-9=Date&Time
=AM/PM
G
=Save
If a power failure occurs, the
time may be shifted. When
“” flashes on the base unit
display, adjust the date/time.
For Caller ID service users (p. 40)
•The Caller ID information will reset the clock after the first ring if the adjusted
time is incorrect.
•
If the time has not previously been set, the Caller ID information will not adjust the clock.
•
The Caller ID information will automatically adjust the clock for daylight saving time.
Date:2002.01.01
Time:12:00 AM
IH
0-9=Date&Time
=AM/PM
G
=Save
Ringer setting
H
Date and time
Copy directory
Date:2002.04.07
Time:09:30 AM
IH
0-9=Date&Time
=AM/PM
G
=Save
---------------
H
Save directory
Ringer setting